How Many Solar Panels Do You Need to Run a 1.5 Ton Inverter AC? Leave a comment

How many solar panels does a 1.5 ton inverter AC need? This is the question we hear most in summer. In short, the answer is six 645 W panels for one AC, with a little left over for fans and lights. The rest of this post shows where that number comes from, so you can redo it for your own AC.

Step 1: how much power a 1.5 ton inverter AC draws

For example, take the Panasonic 1.5 ton DC inverter AC. Its listed rated input is 1,730 W and its maximum is 2,700 W. An inverter AC pulls close to its maximum when it starts on a hot afternoon, and then settles to the rated figure or lower once the room is cool.

First, check the rating plate on your own indoor unit for these two numbers. However, older non-inverter ACs draw more and have a much harder start, so the figures below will be too low for them.

Step 2: how much one panel really gives

A Jinko Tiger Neo 645W panel produces 645 W in test conditions at a cell temperature of 25°C. However, a Pakistani rooftop in June is much hotter than that, and the Jinko Solar datasheet shows a loss of 0.29% for every degree above 25°C. In addition, dust, cable and inverter losses reduce the output. Therefore, a fair working figure is about 80% of the rated power, or roughly 500 W per panel in strong sun. Our Jinko Tiger Neo guide explains these figures.

Step 3: the calculation

WorkingResult
Run the AC at its rated draw1,730 W ÷ 500 W per panel4 panels
Cover the start-up peak2,700 W ÷ 500 W per panel6 panels
Supply 8 hours of use a day13.8 kWh ÷ 2.6 kWh per panel per day6 panels

Therefore, one 1.5 ton inverter AC needs six panels in the worst case. The daily figure assumes five hours of full sun, which is a reasonable average for most of Pakistan, and the AC running at its rated draw for eight hours. In practice, the compressor slows down once the room is cool, so six panels leave a margin.

Six of these panels make a 3.87 kW array. At today’s price, that is Rs 154,800 for the panels alone.

Running a 1.5 ton inverter AC at night

Panels do nothing after sunset, so night use comes from a battery or the grid. For example, a 5 kWh lithium battery with 4.6 kWh usable runs this AC for a little over two and a half hours at its full rated draw. However, it lasts longer in practice because the AC throttles back overnight. For a full night on battery, plan for two units. Our battery sizing guide shows the full method.

The full system for one 1.5 ton inverter AC

The system has three main parts: six Jinko Tiger Neo 645W panels, one SAJ 6kW hybrid inverter and one Zilo Nexa 5kWh lithium battery.

Today’s total for these three items is Rs 538,550. However, mounting structure, cables, breakers and installation are extra and depend on your roof.

A 6kW inverter is more than one AC needs. However, we suggest it because the same inverter then carries the rest of the house. In addition, you can add a second AC later by adding panels instead of replacing the inverter.

Two ACs, or a different panel

  • Two 1.5 ton ACs: about 12 panels of 645 W. Both compressors rarely start at the same moment, so you do not need to double the start-up margin.
  • Smaller panels: divide by the panel’s own working output. For example, a 585 W panel gives about 470 W in strong sun, so the same AC needs six with almost no margin. Therefore, seven is safer.
  • Other panels we stock: Longi Hi-MO X10 645W and Aiko 635W N-type.

Which 1.5 ton inverter AC suits solar

A DC 1.5 ton inverter AC is the right match for solar because it starts gently and adjusts its speed. Both of these are 18,000 BTU inverter units.

Common questions

Can I run a 1.5 ton AC directly on panels without a battery?

Yes, during the day, with a hybrid inverter that blends solar and grid. When a cloud passes, the inverter takes the shortfall from the grid. However, without the grid or a battery, the AC will trip whenever solar output drops.

Is a 3kW system enough for one AC?

It can keep the AC running once the room is cool. However, it leaves no margin for the start-up peak or for anything else in the house. Therefore, six panels is the comfortable minimum.

Does a non-inverter AC work on solar?

It works, but its start-up surge is several times its running power, so it needs a larger inverter and more panels. As a result, replacing it with a 1.5 ton inverter AC usually costs less than oversizing the solar system.

Want the numbers for your own house? Then send us your AC models and monthly units, and we will size the system.

Leave a Reply

Your email address will not be published. Required fields are marked *