The right tubular battery settings can add years to a battery bank. The wrong ones boil the water away or leave the plates half charged. However, most inverters in Pakistan leave the shop on default values. Therefore, check these four settings on the day of installation.
Setting 1: battery type
Battery type is the first of the tubular battery settings to check. Most inverters offer a short list such as AGM, flooded and user-defined. A tubular battery is a flooded lead-acid battery, so choose flooded. If the battery maker gives exact voltages, then choose user-defined and enter them.
Setting 2: charge voltages
Two voltages matter. The bulk voltage fills the battery, and the float voltage keeps it full. The battery’s label or warranty card states both, so use those figures. Typical values for a tubular battery are:
| Per 12 V battery | 24 V bank | 48 V bank | |
|---|---|---|---|
| Bulk or absorption | 14.4 to 14.8 V | 28.8 to 29.6 V | 57.6 to 59.2 V |
| Float | 13.5 to 13.8 V | 27.0 to 27.6 V | 54.0 to 55.2 V |
If the bulk voltage is too low, the battery never fills. In contrast, if it is too high, the battery loses water quickly.
Setting 3: charge current
Of all tubular battery settings, charge current is the one installers skip most often. A tubular battery prefers a slow charge. As a rule of thumb, set the charge current to about one tenth of the battery’s capacity. For example, a 185 Ah battery takes about 18 to 20 A. Therefore, a large solar array needs this limit, or it will push too much current at midday.
Setting 4: low-voltage cut-off
Among tubular battery settings, the cut-off protects the plates. Deep discharge shortens tubular battery life more than anything else. So set the cut-off high enough to stop at about half charge. Many installers use about 11.5 V per battery under load, although you should follow the maker’s figure.
Tubular battery settings for solar charging
If you want the battery to charge only from solar, set the charger source to solar. However, allow grid charging before a long outage, because a tubular battery needs many hours to fill.
Care that tubular battery settings cannot replace
Good tubular battery settings still need basic care:
- First, check the water level every month and top up with distilled water.
- Also keep the terminals clean and tight.
- Then give the battery a ventilated place, because it releases gas while charging.
- Finally, replace all batteries in a bank together, since an old one drags down the new ones.
Exide TR-1800 5P 185Ah Heavy Duty Tall Tubular BatteryRs 56,870View product
AGS SP-2000 9PL 180AH Tall Tubular BatteryRs 66,000View productWhen to move to lithium
If the bank needs replacing anyway, compare the cost over ten years first. Our lithium vs tubular battery comparison works through the numbers. For inverters that support both types, see the comparison of 6kW hybrid inverters. Battery makers such as Dyness publish the lithium equivalents.
Common questions
Do tubular battery settings differ between brands?
Slightly. Therefore, always start from the label or warranty card of your own battery.
Why does my tubular battery need water every week?
The charge voltage or current is probably too high. So check settings 2 and 3.
Should I use the equalisation setting?
Only if the battery maker recommends it. Otherwise, leave it off, because it uses extra water.