Can you fit a lithium battery on an old inverter? Many owners ask this when their tubular batteries wear out. The answer depends on three checks. Therefore, go through them before you buy, because the wrong match can damage a new battery.
Check 1: battery voltage
First, find the battery voltage your inverter needs. It will be 12 V, 24 V or 48 V, and the label or manual states it. A lithium battery on an old inverter must match that voltage.
| Inverter battery voltage | Lithium options |
|---|---|
| 12 V | Dyness AR1.2 or Zilo Nexa Cube |
| 24 V | Dyness DL2.5 or Zilo Nexa 2.5kWh |
| 48 V | Dyness DL5.0F or Zilo Nexa 5kWh |
Check 2: charge settings
This check decides most cases of a lithium battery on an old inverter. Open the battery type menu on the inverter and see which of these it offers:
- A lithium option: then the inverter supports lithium, and you can go ahead.
- A user-defined option: you can set the charge voltages yourself, so a lithium battery often works if you enter the values from its datasheet.
- Only fixed lead-acid modes: these may charge too high or run an equalisation cycle. In that case, do not connect a lithium battery.
For example, a 51.2 V lithium battery typically works between 44.8 V and 57.6 V. Therefore, the inverter must never push it above that upper figure.
Check 3: communication
Newer hybrid inverters talk to the battery through a data cable. Older units usually cannot. However, a lithium battery on an old inverter can still run in voltage mode, where the inverter judges the charge level from voltage alone. It works, although the charge reading is less accurate.
When a lithium battery on an old inverter is a bad idea
- First, the inverter has no user-defined battery mode.
- Also, you cannot limit the charger to the battery’s safe voltage.
- Finally, the inverter is already failing, so a new battery will outlive it by years.
In those cases, replace both together. Our comparison of 6kW hybrid inverters lists units that support lithium, and the Dyness site lists compatible inverter brands.
Dyness DL5.0F Lithium-Ion Battery - 51.2V 100AH IP20 5.12kWhRs 230,000View product
Zilo Nexa 5kWh 51.2V 100Ah Lithium BatteryRs 200,000View product
SAJ 6kW Single Phase Hybrid InverterRs 183,750View productIs a lithium battery on an old inverter worth it?
Usually yes, if the checks pass. A lithium battery on an old inverter lasts far longer than a tubular bank and needs no water. For the numbers, see our lithium vs tubular battery comparison.
Common questions
Will a lithium battery on an old inverter charge fully?
Yes, provided that the charge voltage matches the battery’s datasheet. However, if the inverter stops too early, raise the setting within the allowed range.
Do I need a new charger or cable?
You need battery cables rated for the current, and a DC breaker. Also ask whether the battery needs its own data cable.
Can I keep one tubular battery alongside the lithium?
No, because the two types charge at different voltages. So use one type only.